| RECORDING
INSTITUTE OF DETROIT |
TASCAM TMD-8000 |
| MODULE CONFIGURATION
BUTTON GUIDE |
| When you push the module button, the following screen will appear: |
|
This gives you all of the regular channel parameter
settings for one channel. Understanding the various parts of this display will allow
you to understand most of the configuration button screens. Click
on any part of the screen for an explanation of the display and the parameters that can be
set. Moving the cursor to the part of the screen
allows the parameter to be set with the jog wheel and the POD Controllers (as discussed on
the Pod Controller Display Guide page). |
|
|
CHANNEL DISPLAY |
|
This displays the number of the
current selected channel. If you selected Tape Return channel 9, it would say
"MTR9" and the arrow would point down (to show you it was the lower row of
faders #9). If you selected Stereo Return channel 6, it would say
"ST-RTN6" and the arrow would point up showing it was in the upper row of faders. |
|
4 BAND EQUALIZER |
|
This displays the controls and a frequency response of the
equalization. For a complete guide to equalization and filter controls available, go
here. |
|
DEDICATED BUTTONS |
|
This display shows the status of the Selected Channel Dedicated
Buttons. |
|
AUX SENDS |
|
This display shows you the level of the
aux sends as well as Pre/Post selection and allows the send to be turned on or off. |
|
PAD |
|
This display controls the setting for the
channel's digital pad and allows the channel's polarity ("phase") to be
reversed. |
|
PAN |
|
The Pan display shows you the pan pot
position for the channel's pan pot. The "C" button icon allows the pan to
be centered in one push of a button. The Gang button will gang the even channel to
the odd channel. (The Gang button is displayed on odd channel pan pot displays
only). |
|
GROUPING DISPLAY |
|
The Grouping control will show
which cut group and which fader group this channel is assigned to (if any). The grouping
controls are in the master section for group cut masters
or group master faders. |
|
CHANNEL METER |
|
The Channel Meter display shows the level of the signal in the
channel and whether the meter is before ("Pre") or after ("Post") the
equalizer in the channel. |
|
DYNAMICS METER |
|
The Dynamics Meter shows the action of the dynamics processor
assisnbed to this chanell (ik one is so assigned). |
|
FADER POSITION |
|
This display shows the fader setting for the channel. |
|
CHANNEL ASSIGNMENT |
|
The Channel Assignment display shows the assignment of the
channel to recording busses ("1-8"), the mix buss ("ST") or directly
to a tape machine track ("D"). |
|
|